Ftp Server Configuration Example - HP 830 Series Configuration Manual

Step
4. Assign FTP service
to the user account.
5. Configure
authorization
attributes.
For more information about the local-user, password, service-type ftp, and authorization-attribute
commands, see Security Command Reference.

FTP server configuration example

The configuration example was created on the 10500/7500 20G unified wired-WLAN module and
might vary with device models.
When configuring the 10500/7500 20G unified wired-WLAN module, make sure the settings are
correct (including VLAN settings) on the internal Ethernet interface that connects the module to the switch.
For more information, see HP 10500/7500 20G Unified Wired-WLAN Module Fundamentals
Configuration Guide.
By default, the aggregate interfaces between the access controller engine and the switching engine on
an 830 switch are Access interfaces in VLAN 1. When configuring the two aggregate interfaces, make
sure their permitted VLANs are the same. HP also recommends setting their link type to be the same.
Network requirements
Create a local user account with the username abc and password abc and enable FTP server on the AC
in Figure 25. Use the user account to log in to the FTP server from the FTP client, upload the file newest.bin
from the FTP client to the FTP server, and download the configuration file config.cfg from the FTP server
to the FTP client for backup.
Figure 25 Network diagram
Configuration procedure
1. Configure the AC (FTP server):
# Create a local user account abc, set its password to abc and the user privilege level to level 3 (the
manage level), specify the root directory of the Flash as the authorized directory, and specify the
service type as FTP.
<AC> system-view
[AC] local-user abc
[AC-luser-abc] password simple abc
[AC-luser-abc] authorization-attribute level 3
[AC-luser-abc] authorization-attribute work-directory flash:/
Command
service-type ftp
authorization-attribute { acl
acl-number | callback-number
callback-number | idle-cut minute
| level level | user-profile
profile-name | vlan vlan-id |
work-directory directory-name } *
67
Remarks
By default, no service type is specified. If the
FTP service is specified, the root directory of
the device is by default used.
Optional.
By default, the FTP/SFTP users can access the
root directory of the device, and the user level
is 0. You can change the default configuration
using this command.