HP 830 Series Configuration Manual page 35

After the configuration is complete, change the terminal settings on the configuration terminal and make
sure they are the same as the settings on the device.
To configure common settings for a console user interface:
Step
1. Enter system view.
2. Enter console user interface
view.
3. Set the baud rate.
4. Specify the parity check
mode.
5. Specify the number of stop
bits.
6. Specify the number of data
bits in each character.
7. Define the shortcut key for
starting a terminal session.
8. Define a shortcut key for
terminating tasks.
9. Specify the terminal display
type.
10. Configure the user privilege
level for login users.
Command
system-view
user-interface console 0
speed speed-value
parity { even | none | odd }
stopbits { 1 | 2 }
databits { 7 | 8 }
activation-key character
escape-key { default | character }
terminal type { ansi | vt100 }
user privilege level level
29
Remarks
N/A
N/A
By default, the baud rate is 9600
bps.
By default, the parity check mode is
none, and no parity check is
performed.
The default is 1.
Stop bits indicate the end of a
character. The more the stop bits, the
slower the transmission.
The default is 8.
The setting depends on the character
coding type. For example, you can
set it to 7 if standard ASCII
characters are to be sent, and set it
to 8 if extended ASCII characters
are to be sent.
By default, you press Enter to start
the terminal session.
By default, pressing Ctrl+C
terminates a task.
By default, the terminal display type
is ANSI.
The device supports two types of
terminal display: ANSI and VT100.
HP recommends setting the display
type of both the device and the
terminal to VT100. If the device and
the client use different display types
(for example, HyperTerminal or
Telnet terminal) or both are set to
ANSI, when the total number of
characters of the currently edited
command line exceeds 80, an
anomaly such as cursor corruption
or abnormal display of the terminal
display might occur on the client.
By default, the default command
level is 3 for the console user
interface.