Configuring Ftp; Using The Device As An Ftp Client; Establishing An Ftp Connection - HP 830 Series Configuration Manual

Configuring FTP

File Transfer Protocol (FTP) is an application layer protocol based on the client/server model. It is used to
transfer files from one host to another over a TCP/IP network.
FTP server uses TCP port 20 to transfer data and TCP port 21 to transfer control commands. For more
information about FTP, see RFC 959.
FTP supports the following transfer modes:
• Binary mode—Used to transfer image files, such as .app, .bin, and .btm files.
ASCII mode—Used to transfer text files, such as .txt, .bat, and .cfg files.
•
FTP can operate in either of the following modes:
Active mode (PORT)—The FTP server initiates the TCP connection. This mode is not suitable when
•
the FTP client is behind a firewall, for example, when the FTP client resides in a private network.
Passive mode (PASV)—The FTP client initiates the TCP connection. This mode is not suitable when
•
the server does not allow the client to use a random unprivileged port greater than 1024.
FTP operation mode varies depending on the FTP client program.
The device can act as the FTP client or FTP server.
Figure 23 FTP application scenario

Using the device as an FTP client

To connect to an FTP server or enter FTP client view, make sure the following requirements are met:
You have user privilege level 3 (Manage) on the device. Whether you can execute a directory or file
•
management command successfully in FTP client view depends on the authorization settings on the
FTP server.
The device and the FTP server can reach each other.
•
You have a user account (including the username, password, and authorization) on the FTP server.
•
If the FTP server supports anonymous FTP, you can directly access the FTP server without a username
and password.

Establishing an FTP connection

Before you can access the FTP server, use the ftp command in user view or use the open command in FTP
client view to establish a connection to the FTP server.
You can use the ftp client source command to specify a source IP address or source interface for the FTP
packets sent by the device. If a source interface (typically, a loopback interface) is specified, its primary
60