HP 830 Series Configuration Manual page 70

For more information, see HP 10500/7500 20G Unified Wired-WLAN Module Fundamentals
Configuration Guide.
By default, the aggregate interfaces between the access controller engine and the switching engine on
an 830 switch are Access interfaces in VLAN 1. When configuring the two aggregate interfaces, make
sure their permitted VLANs are the same. HP also recommends setting their link type to be the same.
Network requirements
As shown in
PC can reach each other. An account with the username abc and password abc is already configured on
the FTP server.
Log in to the FTP server from the FTP client, download the system software image file newest.bin from the
PC to the AC, and upload the configuration file config.cfg from the AC to the PC for backup.
Figure 24 Network diagram
Configuration procedure
# Examine the storage space of the AC. If the free space is insufficient, use the delete/unreserved file-url
command to delete unused files. (Details not shown.)
# Log in to the server at 10.1.1.1 using the username abc and password abc.
<AC> ftp 10.1.1.1
Trying 10.1.1.1
Press CTRL+K to abort
Connected to 10.1.1.1
220 WFTPD 2.0 service (by Texas Imperial Software) ready for new user
User(10.1.1.1:(none)):abc
331 Give me your password, please
Password:
230 Logged in successfully
# Set the file transfer mode to binary.
[ftp] binary
200 Type set to I.
# Download the system software image file newest.bin from the PC to the AC.
[ftp] get newest.bin
227 Entering Passive Mode (10,1,1,1,10,68).
125 BINARY mode data connection already open, transfer starting for /newest.bin.
226 Transfer complete.
FTP: 23951480 byte(s) received in 95.399 second(s), 251.00K byte(s)/sec.
# Set the file transfer mode to ASCII, and upload the configuration file config.cfg from the AC to the PC
for backup.
[ftp] ascii
[ftp] put config.cfg back-config.cfg
227 Entering Passive Mode (10,1,1,1,4,2).
Figure 24, the AC acts as the FTP client and the PC acts as the FTP server. The AC and the
64