Displaying And Maintaining Software Upgrade; Software Upgrade Examples - HP 830 Series Configuration Manual

Stopping running patches
When you stop running a patch, the patch state becomes DEACTIVE, and the system runs the way it did
before the patch was installed.
To stop running patches:
Step
1. Enter system view.
2. Stop running patches.
Removing patches from the patch memory area
After being removed from the patch memory area, a patch is still retained in IDLE state in the storage
medium. The system runs the way it did before the patch was installed.
To remove patches from the patch memory area:
Step
1. Enter system view.
2. Remove patches from the patch memory area.

Displaying and maintaining software upgrade

Task
Display information about the
system software image.
Display information about the
patch package.
Display patch information.

Software upgrade examples

The configuration examples were created on the 10500/7500 20G unified wired-WLAN module and
may vary with device models.
When configuring the 10500/7500 20G unified wired-WLAN module, make sure the settings are
correct (including VLAN settings) on the internal Ethernet interface that connects the module to the switch.
For more information, see HP 10500 & 7500 20G Unified Wired-WLAN Module Fundamentals
Configuration Guide.
By default, the aggregate interfaces between the access controller engine and the switching engine on
an 830 switch are Access interfaces in VLAN 1. When configuring the two aggregate interfaces, make
sure their permitted VLANs are the same. HP also recommends setting their link type to be the same.
Command
system-view
patch deactive [ patch-number ]
Command
system-view
patch delete [ patch-number ]
Command
display boot-loader [ | { begin | exclude
| include } regular-expression ]
display patch [ | { begin | exclude |
include } regular-expression ]
display patch information [ | { begin |
exclude | include } regular-expression ]
93
Remarks
Available in any view.
Available in any view.
Available in any view.