Table of Contents
Advertisement
4. Attach Extender Brackets to Slide Assemblies
1. Ensure the Middle Slide Member, Figure 2-(2), is extended forward from the outer slide sleeve (outer
slide member), Figure 2-(3).
Note: The Bracket to Slide Assy. fasteners are a screw secured with a serrated nut.
2. Attach the long bracket to the rear of the slide assembly with two #8-32 x 3/8 in. screws and serrated
nuts (Figure 4). Insert the FHP screws from the inside out, so the nut is on the outside of the slide as-
sembly.
Do not over tighten the fasteners until the bracket assemblies have been mounted on the 4-Post rack.
3. Repeat Step 2 for the second long bracket.
4. Attach the front (short) bracket to the front of the slide assembly with two (2) #8-32 x 3/8 in. screws
and serrated nuts (Figure 4). Insert the screws through the access holes provided in the Middle Slide
Member.
Do not over tighten the fasteners until the bracket assemblies have been mounted on the 4-Post rack.
5. Repeat step 4 for the second front bracket.
Long Bracket
FIGURE 4: ATTACH EXTENDER BRACKETS TO SLIDE ASSEMBLY
5. Attach Slide Assemblies to 4-Post Rack
1. Remove the cage nuts from the Slide kit.
2. Clip one cage nut (Cage Nut, 1/4"-20) from the 92800 kit over each post's
rack mounting hole at the desired elevation.
NOTE: Ensure all bracket slots align with the rack rail mounting holes to
establish the bottom unit elevation.
NOTE: If installing more than one T1000 module, begin with the lowest
module first.
3. Clip a second cage nut 1.75 in. above each cage nut installed in step 1
(Figure 5). If using all four mounting slots, install all four cage nuts.
4. If more than one module is being installed for the T1000 system, install
the next set of cage nuts from the other module's 4-Post Slide Kit three
(3) Rack Units (5 1/4") above the first set of cage nuts (Figure 5). Repeat
steps 2-3.
5. Repeat steps 2-4 until cage nuts for all the modules
in the system have been clipped on the 4-Post rack.
6. Bolt the Side Rail/Bracket assembly to the 4-Post
Rack using two 1/4"-20 x 5/8" bolts each on the front
T1000 Series UPS Installation and Operation Manual – 91074-002
1 in.
(25 mm)
Fastener Insertion
Slide Assembly (shown w/o
Middle Member for clarity)
1.75 in.
(44 mm)
Front
Short Bracket
FIGURE 5 CAGE NUT
INSTALLATION
E-9
Advertisement
Table of Contents
