Toshiba T1000 Series Installation Instructions

T1000 Series UPS 4-Post Rack Slide Kit

Installation Instructions- 94034-000

1. 4-Post Rack Slide Kit
Use the 4-Post Rack Slide Kit 92800 (1 kit per module) to mount a T1000 module with slides in a 19-inch,
4-Post rack. The slide assemblies are non-handed, and are provided with a lock-open feature and a quick
disconnect for the Inner Slide Member. When the Inner Slide Member is disconnected, the E-Z Rail latch in
the slide assembly locks the Middle Member in the fully open position until the Inner Member is reinstalled.
2. Contents - 4-Post Rack Slide Installation Kit (92800)
1 ea.: T1000 Series UPS 4-Post Rack Slide Kit Installation Instructions - 94034
2 ea.: Slide, 22 in., 370EZ-22
2 ea.: Bracket, Front Offset, SPO-538
2 ea.: Bracket, Rear Offset, SPO-552
8 ea: Screw, FHP (Flat Head Phillips) 8-32 x 3/8 in.
8 ea: Nut, serrated head, 8-32
8 ea: Screw, PHP, (Pan Head Phillips) 8-32 x 1/4 in.
16 ea.: Cage Nut, 1/4"-20
16 ea.: SEMS Hex bolt, 1/4"-20 x 5/8" (with assembled washer)
3. Attach E-Z Rail to Module
4
1
1. Remove the EZ Rail (Slide Rail Inner Member), Figure 2-(1), from the Slide Rail Middle Member, Fig-
ure 2-(2), by pressing the E-Z Rail Latch and sliding the EZ Rail out of the Middle Member. Repeat
for the second Slide Assembly.
2. Attach an EZ Rail to each side of the UPS module using 4 x Phillips 8-32 x 1/4". Orient the inner
Slide Member so the rounded end is towards the rear of the module. (Figure 3)
FIGURE 3: INSTALL INNER SLIDE MEMBER ON LEFT AND RIGHT SIDES OF MODULE(S)
T1000 Series UPS 4-Post Rack Slide Kit Installation Instructions 94034-000
No.
1 Slide Rail Inner Member (EZ Rail)
2 Slide Rail Middle Member
3 Slide Rail Outer Member (Outer Rail Sleeve)
4 E-Z Rail Latch
FIGURE 2 SLIDE ASSEMBLY
7 in.
(178 mm)
8-32 x 1/4 in.
2
ITEM
7 in. 5 in.
(178 mm) (127 mm)
4 @ PHP
3
Slide Rail
Inner Member
1