Getting Started; Preparing The Site; Creating An Installation Plan - Powerware 9315 Installation & Operation Manual

This section describes the Powerware Fixed Master Sync Control. It
contains instructions for inspecting the unit and basic site preparation
procedures.
The Powerware Fixed Master Sync Control is shipped as a separate item. It weighs
approximately 80 lbs and can be mounted on any surface that can safely bear its
weight. See Appendix A for complete dimensions and wiring interconnection data.

Preparing the Site

For the Powerware Fixed Master Sync Control to operate at peak efficiency, the
installation site should meet the environmental parameters outlined in the
Powerware 9315 Operation manual provided with the single module Powerware
9315 UPS system or the Installation and Operation manual provided with the
Powerware Hot Sync---Capacity system. The operating environment must
accommodate the size and weight requirements supplied in the Powerware 9315
Installation manual provided with the single module Powerware 9315 UPS system
or the Powerware 9315 Installation and Operation manual provided with the
Powerware Hot Sync---Capacity system.
The basic environmental requirements for operation of the Powerware Fixed Master
Sync Control are:
Ambient Temperature Range:
Recommended Operating Range: 20---25˚C (68---77˚F)
Maximum Relative Humidity:
The Powerware Fixed Master Sync Control uses convection cooling to regulate
internal component temperature.

Creating an Installation Plan

Before beginning to install the Powerware Fixed Master Sync Control, read and
understand how this manual applies to the system being installed. It is important
to note that UPS module installation procedures are contained in the Powerware
9315 Installation and/or Powerware 9315 Installation/Operation manual provided
with the single module Powerware 9315 UPS system and the System Bypass
Module (SBM) installation procedures are contained in the Powerware 9315
Installation and Operation manual provided with the Powerware Hot Sync---Capacity
system. It is recommended to first understand how to install the UPS modules or
the SBM. The information in Chapter 2 of this manual is a guide for installation of
the Powerware Fixed Master Sync Control to the UPS modules or SBM.
NOTE: Installation of the Powerware Fixed Master Sync Control may require making
interconnections to equipment that is not a Powerware product. Refer to the
Installation manual provided with the OEM equipment.
Powerware 9315 Fixed Master Sync Control
164201325 Rev. A 060203

Getting Started

0---40˚C (32---104˚F)
95% noncondensing
5