Powerware 9315 Installation & Operation Manual page 44

SINGLE MODULE 30- -500 POWERWARE 9315 UPS SYSTEM CONTROL WIRING
From Slave UPS
(refer to dwg
164201325- -2)
TB6--3
TB6--4
TB6--5
TB6--6
TB6--7
TB6--11
TB6--12
TB6--13
TB6--8
TB6--9
TB6--10
TB1--9
TB1--10
TB1--7
TB1--8
Remove the following jumpers, if connected,
from UPS module terminal block TB6 when
installing the Sync Control:
From
TB6--5
TB6--6
TB6--7
Field Wiring Requirements:
S Minimum insulation rating: 600 volts
S Use 14 AWG wiring for interconnections between
the Sync Control and the UPS modules.
S Install using Class 1 wiring methods.
A ---16
INTERCONNECTIONS
To Sync Control
(refer to dwg
164201325- -1)
TB1--1
TB1--2
TB1--4
TB1--5
TB1--6
TB1--13
TB1--14
TB1--15
TB1--16
TB1--17
REFERENCE VOLTS REFERENCE VOLTS
TB1--18
TB1--22
BYPASS DISABLED BYPASS DISABLED
TB1--23
TB1--26
TB1--27
CAUTION
To
TB6--8
TB6--9
TB6--10
Description
UPS ON BYPASS UPS ON BYPASS
BYPASS VOLTAGE BYPASS VOLTAGE
LOAD VOLTAGE LOAD VOLTAGE
PLC FAILURE PLC FAILURE
ALARM
DESCRIPTION:
Table 1 -- Single Module Powerware 9315 UPS System
Control Wiring Interconnections (Slave)
DRAWING NO:
Remarks
Twist Together Twist Together
Twist Together Twist Together
Twist Together Twist Together
Twist Together Twist Together
Twist Together Twist Together
Twist Together Twist Together
SHEET:
164201325---9
Powerware 9315 Fixed Master Sync Control
164201325 Rev. A 060203
1 of 2