Powerware 9315 Installation & Operation Manual page 48

POWERWARE 9315 UPS HOT SYNC-CAPACITY SYSTEM CONTROL
From SBM
(Master)
TB6--1
TB6--2
TB6--7
TB6--8
TB6--9
Install the following jumpers, if removed, on
SBM terminal block TB6 when installing the
Fixed Master Sync Control:
From
TB6--1
TB6--2
TB6--3
INTERCONNECTIONS FOR EQUIPMENT OTHER THAN POWERWARE PRODUCTS
From
Master Source
Phase A
Phase B
Phase A
Phase B
Phase C
Note: If using the utility source as master or a source where bypass does not exist, add
jumpers to the fixed master sync control as shown below:
FROM
TB1--10
TB1--11
Field Wiring Requirements:
S Minimum insulation rating: 600 volts
S Use 14 AWG wiring for interconnections between
the Sync Control and the UPS modules.
S Install using Class 1 wiring methods.
A ---20
WIRING INTERCONNECTIONS
To Sync Control
TB1--10
BYPASS REFERENCE BYPASS REFERENCE
TB1--11
TB1--7
TB1--8
TB1--9
To
TB6--4
TB6--5
TB6--6
(Refer to Other Vendor Installation Manual)
To Sync Control
TB1--10
TB1--11
TB1--7
TB1--8
TB1--9
TO
TB1--7
TB1--8
Description
VOLTAGE
SYNC VOLTAGE SYNC VOLTAGE
Description
BYPASS REFERENCE
VOLTAGE VOLTAGE
(See Note)
SYNC VOLTAGE SYNC VOLTAGE
DESCRIPTION:
Table 3 -- Powerware System Control
Wiring Interconnections (Master)
DRAWING NO:
164201325---11
Remarks
Twist Together
Twist Together
Twist Together
Twist Together
Twist Together
Remarks
Twist Together Twist Together
Twist Together Twist Together
SHEET:
Powerware 9315 Fixed Master Sync Control
164201325 Rev. A 060203
2 of 2