Cross-References - KMC Controls CTE-5202 Application Manual

Cross-References

Barber Colman (TAC, Invensys, Schneider Electric)
TP-8101, TP-8102, and TP-8103
For wiring and sample applications, see
KMC /
Anemostat
Nailor /
(East/West)*
Dynacon*
13-27,
CTE-1001
004100
CTE-1002
CTE-1003 13-29
CTE-1004 13-28
CTE-1005
CTE-1008
CTE-1101 004643
CTE-1103
CTE-1105
CTE-1108
*NOTE: CTE-1x0x thermostats require a power supply of 9.1 VDC, typically supplied by a CEP/CSP-4xxx controller/actuator, and they
have a 0–6 VDC output range. The CTE-5202 can also operate on the 9.1 VDC power supplied by CEP/CSP-4xxx controller-actuators,
but the CTE-5202's outputs will be reduced to a maximum of about 5.3 VDC (or a maximum of about 2000 fpm from the CEP/CSP-
4xxx). In almost all such applications, this is adequate. In a rare application that requires a full 6 VDC output (or 3000 fpm maximum
from the CEP/CSP-4xxx), the CTE-5202 can be powered by the 24 VAC transformer, which can be easily done by switching the wire
from Terminal #5 (+9.1 VDC) to Terminal #10 (24 VAC, phase) on the CEP/CSP-4xxx. See
44. See also the CEP-4000 Series Applications
General Information (All Applications)
Thermostat Replaced
TP-8124 and TP-8125
Barber Colman TP-81xx Thermostats Replacement Applications on page
Thermostat Replaced
Metal
Metalaire*
Industries*
B3-3001-
01EC-2146
01EC-2129 THM1004
THM1005
THM1101
01EC-9229 THM1103
THM1105
Guide.
ASC /
Nailor*
Titus*
10027401
#3 (disregard cooling
setpoint) or #1 (with
8K–10K ohm resistor for
015 or
B3-015
10027403
#1 (setback used for night
#1 (setback used for day
10027415
#1 (single duct) or #3
10027411
10027413
#1 (setback used for day
8
CTE-5202 Sequence Selected
#1
#3
CTE-5202
Sequence Replacement
Selected Applications
#1 See
RA mode)
#3
page 47
#2 See
setpoint)
setpoint)
page
See
#1
page
See
(dual duct)
#1
setpoint)
9.1 VDC vs. 24 VAC Power Options on page
CTE-5202 Applications Guide, AN0912A Rev. D
54.
Example
page 45
page 49
and
45, page 50, and
page 51
48, page 52, and
page 53