Advertisement
Required Tools
• digital voltmeter
• small phillips screwdriver
• small flatblade screwdriver
• keyhole saw
Mounting
Standard:
•
The base unit's mounting slots are designed to align with the
holes in a standard 2" x 4" (51x102) handy conduit box.
•
Use a 2" (51) deep box if using conduit.
•
Normal screw and anchor systems may be used on solid
walls.
Hollow wall:
1. Cut a 3-3/4" x 1-3/4" rectangular opening in the wall.
(Check if unit is horizontal or vertical before cutting)
2. Make all necessary connections
3. Insert Toggle Bolt Assembly (HMO-5001, ordered separately)
through the wall and tighten.
Care should be taken not to bend or flex the base of the
thermostat.
Wiring
Typically, T1 and T3 are used for cooling and T2
and T4 are used for heating. Refer to the wiring
diagram.
Dual Temperature Room Thermostat
Installation Guide
CTE –1005, 1008, 1105, 1108
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for KMC Controls CTE-1005
Summary of Contents for KMC Controls CTE-1005
- Page 1 Dual Temperature Room Thermostat CTE –1005, 1008, 1105, 1108 Installation Guide Required Tools • digital voltmeter • small phillips screwdriver • small flatblade screwdriver • keyhole saw Mounting Standard: • The base unit’s mounting slots are designed to align with the holes in a standard 2"...
- Page 2 Maintenance No routine maintenance is required. Each component is designed for dependable, long term reliability and performance. Careful installation will also ensure long term reliability and performance. KMC Controls P.O. Box 497 19476 Industrial Drive New Paris, IN 46553 U.S.A.
Need help?
Do you have a question about the CTE-1005 and is the answer not in the manual?
Questions and answers