Setup & Installation; Note The Wireless Mac Addresses; Setup Guide Assumed Defaults - TRENDnet TEW-740APBO User Manual

TRENDnet User's Guide
Setup & Installation
The intended purpose and application for this product is to extend network connectivity
across long physical distances outside of an area or building that lacks local connectivity
using point to point wireless bridge capability using 802.11 standards.
Although this product supports multiple wireless modes, the basic installation will only
cover the primary application of point to point wireless connectivity.
Minimum Requirements

Computer with RJ-45 Ethernet port and web browser

2 x RJ-45 Ethernet cables (not included)

Phillips screwdriver (not included)
Important Note:
The access point does not support standard IEEE 802.3at/af PoE/PoE+. Only the included
proprietary PoE injector may be used to supply power to the access point. For safety,
use only the included PoE injector to supply power to the access point.
It is strongly recommended that you configure the access points first before mounting
them in their desired locations.
Access Point Default Settings
LAN IP Address: 192.168.10.100
LAN Subnet Mask: 255.255.255.0
User: admin
Password: admin
The following steps assume you are setting up and installation two TRENDnet TEW-
740APBO access points in point to point configuration.
© Copyright 2016 TRENDnet. All Rights Reserved.

Note the Wireless MAC Addresses

Please check the device label on both access points and write down or note the item
labeled MAC1 from both access points. MAC1 is the wireless MAC address assigned to
each access point and will be used later in the configuration steps.

Setup Guide Assumed Defaults

In this guide, we will assume the following defaults and settings:

TEW-740APBO #1 MAC1: 00:11:22:33:44:55

TEW-740ABPO #2 MAC1: AA:BB:CC:DD:EE:FF

Network Router/Gateway IP Address/Netmask: 192.168.10.1 / 255.255.255.0

Network Router/Gateway DHCP IP Pool: 192.168.10.101-192.168.10.199
Note: Please note that if your existing network router/gateway IP address/subnet
settings are different than the network settings assumed above, you will need to modify
the assigned IP configuration to each access point accordingly to within you specific
subnet.
Before mounting the access points in their desired locations, please configure access
points first.
TEW-740APBO
8