Tew-740Apbo Setup & Installation; Note The Wifi Mac Addresses - TRENDnet TEW-740APBO User Manual

TRENDnet User's Guide
TEW-740APBO Setup & Installation
The following installation procedure assumes you are setting up and installing two
TRENDnet TEW-740APBO H/W: v2.XR access points in WDS bridge point-to-point
configuration.

Note the WiFi MAC Addresses

1. Remove the cover of the access points by pulling and holding the tab in the vertical
direction upward (as shown in the picture below) and sliding the cover in the two
locations noted away from the access point.
© Copyright 2017 TRENDnet. All Rights Reserved.
2. On the device label located inside, write down the WiFi MAC of each access point.
Note: In this installation procedure example, we will assume the WiFi MAC addresses:
WiFi MAC Address 00:11:22:33:44:00
Router Settings:
Router/Default Gateway IP Address: 192.168.10.1
Subnet Mask: 255.255.255.0
In this installation procedure example, we will configure the TEW-740APBO access points
will be configured with the following settings:
IP Address
Netmask (Subnet Mask)
IP Gateway (Default Gateway)
Primary DNS
Wireless Channel (Default)
Mode
WDS Encryption
TEW-740APBO / TEW-740APBO2K
TEW-740APBO #1 TEW-740APBO #2
00:11:22:33:44:11
TEW-740APBO #1 TEW-740APBO #2
192.168.10.50 192.168.10.51
255.255.255.0 255.255.255.0
192.168.10.1 192.168.10.1
192.168.10.1 192.168.10.1
1 1
WDS WDS
AES AES
7