Configure Lan Ip; Ap Mode Configuration; External Network Connection; Network Requirement - TRENDnet TEW-740APBO User Manual

TRENDnet User's Guide

AP Mode Configuration

When AP mode is chosen, the system can be configured as an Access Point. This section
provides detailed explanation for users to configure in the AP mode with help of
illustrations. In the AP mode, functions listed in the table below are also available from
the Web-based GUI interface.

External Network Connection

Network Requirement

Normally, access point connects to a wired LAN and provides a wireless connection
point to associate with wireless client as shown in Figure 3-1. Then, Wireless clients
could access to LAN or Internet by associating themselves with the access point set in AP
mode.

Configure LAN IP

Here are the instructions to setup the local IP Address and Netmask.
Please click on System -> LAN and follow the below setting.
 Mode: Check either "Static IP" or "Dynamic IP" button as desired to set up the
system IP of LAN port.
© Copyright 2016 TRENDnet. All Rights Reserved.
 Static IP: The administrator can manually setup the LAN IP address when static IP
is available/ preferred.
o IP Address : The IP address of the LAN port; default IP address is
192.168.2.254
o IP Netmask : The Subnet mask of the LAN port; default Netmask is
255.255.255.0
o IP Gateway : The default gateway of the LAN port; default Gateway is
192.168.2.1
 Dynamic IP: This configuration type is applicable when the access point is
connected to a network with the presence of a DHCP server; all related IP
information will be provided by the DHCP server automatically.
o Hostname : The Hostname of the LAN port
 DNS: Check either "No Default DNS Server" or "Specify DNS Server IP" button as
desired to set up the system DNS.
o Primary: The IP address of the primary DNS server.
o Secondary: The IP address of the secondary DNS server.
TEW-740APBO
23