Appliance With Built-In Aktivclean Water Softener; Appendix - Meiko FV 40.2 Operating Instructions Manual

Operating instructions
FV 40.2

Appliance with built-in AktivClean water softener

6.2 De-scaling
If the appliance was operated with hard water, the boiler and wash tank could
have lime scale deposits. De-scaling of the tank interior, boiler housing, tank
heating, boiler heating and wash and final rinse system then becomes
necessary.
For de-scaling the appliance, use only products suitable for industrial
dishwashers. Please observe the instructions of the manufacturers of such
products.
After de-scaling the appliance:
Ø Remove the de-scaling agent completely from the appliance. 1 or 2 rinse
cycles with fresh water are necessary to achieve this.
Even small residues of de-scaling agents can be sufficient to destroy plastic
parts and sealing materials!
Appliance with built-in AktivClean water softener
7.1 Initial operation
(Cycle counter set at '0'; EE-Prom new)
Once a program pre-selection key has been pressed, the following program
runs automatically:
- Boiler filling and heating
- Cyclical tank filling and heating
- Boiler filling
- Regeneration without operation of the float switch
Salt container fills with water
See point 5 (Operation) in the Operating Instructions for further procedures or
functions.
7.2 Manual regeneration start
The regeneration can also be started manually, e.g. for testing the function of
the water softener. The 0-key must be pressed for approximately 3 seconds and
kept pressed. The program pre-selection key i must now also be pressed at
the same time until the yellow light in the q field is illuminated. Regeneration
runs automatically, and the regeneration counter is re-set to 0.

Appendix

8.1 Name and address of manufacturer
MEIKO Maschinenbau GmbH & Co. KG
Englerstrasse 3
D-77652 Offenburg
Phone no.: (++ 49) 781 / 203 - 0
Fax no.: (++ 49) 781 / 203 - 1121
www.meiko.de
e-mail: info@meiko.de
- 8 -