Meiko FV 40.2 Operating Instructions Manual page 15

Appliance with AktivClean built-in water softening
Operating instructions
device
FV 40.2
5.3 Capacity of the built-in water softening device between two
regenerations
Hardness (°Gh)
8
10
12
14
16
18
20
22
24
26
28
30
32
34
36
38
40
42
5.4 Regeneration
The automatic regeneration is indicated by a yellow light. The regeneration lasts
approx 8 minutes.
A further programme sequence can take place during this time. If a second
programme cycle is started, the washing time is extended until the regeneration
is completed. The draining pause and the fresh water final rinse only take place
after the regeneration is complete.
A red light indicates when the salt container has to be re-filled. The salt
container is located in the tank. It will take approximately 1.5 kg of regeneration
salt, grain size 0.3 – 1 mm. This quantity is sufficient for about 12 regeneration
cycles. Use a funnel for adding the salt to the container. The seal and the
thread of the salt solution container must be cleaned before closing the
container.
5.5 Fault indications
Yellow light is flashing:
Electronic printed circuit board defective or water softening is not carried out.
Acknowledge the fault with the 0-key.
Should the fault occur again after the next programme cycle, notify the
service engineer.
Capacity (I)
250
200
167
143
125
111
100
91
83
77
71
67
63
59
56
53
50
48
- 7 -