Installation - Yamaha ttr230 Service Manual

3
2
COLUNA DE DIREÇÃO E GUIDÃO
1

INSTALLATION

HANDLE-BARS
Reverse the "REMOVAL" procedures.
1. Lubricate:
• Handle-bars
Lithium-based grease
NOTE:
Before installing the throttle grip on the
handle-bars, apply a thin layer of lithium-
based grease to the right end of the handle-
bars.
2. Install:
• Throttle grip
• Handle-bars
Screw (handle-bars):
15 N.m (1.5 kgf.m; 11 ft.lb)
NOTE:
Align the mark 2 on the handle-bars 1
with the upper end of the lower right
handle-bars fastener 3 and install the
handle-bars.
NOTE:
The upper handle-bars fastener should be
installed with the punch mark (1) towards
the front part.
2 Front
CAUTION:
Tighten the front handle-bars fastener
screws first and, then, tighten the rear
screws.
6-47
FRAME