Wheel Installation; Battery - Yamaha WOLVERINE R MAX 2021 Manual

EBU33090

Wheel installation

1. Install the wheel and the nuts.
2. Lower the vehicle so that the wheel is on
the ground.
3. Tighten the wheel nuts in a crisscross
pattern to the specified torque.
EWB03400
WARNING
Do not reverse the rims on your Yamaha
Wolverine RMAX2 to widen the track
width. Installing wheels improperly in-
creases the risk of wheel failure and acci-
dents.
Tightening torques:
9
Front wheel nut:
95 N·m (9.5 kgf·m, 70 lb·ft)
Rear wheel nut:
95 N·m (9.5 kgf·m, 70 lb·ft)
EBU37470

Battery

This model is equipped with a 12–volt VRLA
(valve–regulated lead–acid) battery. There is
no need to check the electrolyte or to add dis-
tilled water. However, the battery lead con-
nections need to be checked and tightened,
and the battery terminals cleaned if corroded.
If the battery seems to have discharged, re-
charge it as soon as possible.
EWB03410
WARNING
Avoid battery contact with skin, eyes, or
clothing. Shield eyes when working near
batteries. Keep out of reach of children.
You could be poisoned or severely burned
by the sulfuric acid in battery electrolyte. In
case of accidental contact with battery
electrolyte:
EXTERNAL: Flush with water.
9-49