Yamaha ttr230 Service Manual page 168

ENGINE MOUNTING AND ADJUSTMENTS
3
2
5
3
2
1
NOTE:
Install rotor 1 aligning the slot and the key.
Turn starting gear 2 2 clockwise and install
rotor and starting gear.
2
1
6. Install:
NOTE:
Tighten the bolt (rotor) holding the rotor
with the fastener 2.
1
CAUTION:
Prevent the rotor fastener from touching
the cams 3 on the rotor.
7. Install:
4
8. Install:
NOTE:
Tighten the bolts (case cover) in a cross
pattern.
1
9. Connect:
4-74
• Bolt 1 (rotor)
Bolt (rotor):
50 N.m (5.0 Kg.m; 36 ft.Ib)
Rotor fastener:
90890-01701
• Starting gear 1 1
• Shaft 2
• Spacer 3
• Dowel pins 4
• Gasket 5 (case cover)
• Case cover (LH)
Bolt (case cover):
10N.m (1,0 Kg.m; 219,46 cm.Ib)
• Dead center switch wire 1
ENGINE