Yamaha ttr230 Service Manual page 245

STEERING COLUMN AND HANDLE-BARS
1
NOTE:
Attach the torquemeter to the adjusting nut
wrench, forming a right angle (90°).
Adjusting nut (initial torque):
43 N.m (4.3 kgf.m; 31.1 ft.lb)
• Turn the lower board to the right and to
the left, making sure there is no irregular
movement. Then, loosen the nut one turn.
• Tighten the adjusting nut, using the
adjusting nut wrench.
Adjusting nut (final torque):
6.5 N.m (0.65 kgf.m; 4.7 ft.lb)
V V V V V
WARNING
Do not apply excessive torque.
NOTE:
Check the steering column, turning it from
side to side after its adjustment.
If the movement is difficult, loosen the
adjusting nut. If the movement is loose,
repeat the adjustment steps.
*************************************
4. Install:
• Lock washer 1
• Upper board 2
NOTE:
Tighten the upper board anchor nut 2
temporarily.
6-50
FRAME