Chapter 5: Performing An Autotest - Viavi Certifier40G User Manual

Chapter 5: Performing an AUTOTEST

Press the AUTOTEST button once settings and limits have been selected. Certifier will use the
last configuration or factory settings to perform the AUTOTEST if new settings are not
configured.
Certifier will display summarized result with PASS or FAIL once AUTOTEST is completed. Press
the "View" details button to view the comprehensive result or the "Save" button to save the
results.
AUTOTEST overview
Click on the parameter to display a more comprehensive individual result.
In detailed view, loss from the Local to the Remote unit, Limit and Margin will be displayed
for each wavelength for both Single and Multi-mode. If Bi-directional test is selected at the
configuration settings, test result for loss from Remote to Local will be displayed.
Depending on installation requirements, additional application test standards will be
performed during an Autotest if Ethernet Standard and/or Fiber Channel is selected. To
perform additional application standard test, press the SETUP button > Test Settings >
Network Limits.
Detailed view for Single
directional test
Detailed view for Bi-directional
test
5