Chapter 4: Configuring an AUTOTEST
After configuring the system settings, follow these steps to set up an AUTOTEST.
1. Press the SETUP button > Project Settings
a. Site – Create or select a Site
b. Operator – Create or select an Operator
c. Label Source – Select cable labelling scheme. Load labels from USB flash drive
if using List Based Testing (LBT).
d. AutoSave – Enable option for Certifier to auto save every PASS result.
2. Press the SETUP button > Test Settings
Test Limit – Select a test limit
a.
Cable – Create a custom or select cable from list. Select "Generic" if unsure.
b.
Modal Bandwidth - Choose the modal bandwidth of the cable under test.
c.
Leave option unchanged if unsure.
Please ensure you have the following components before conducting the test;
Certifier, Local & Remote units
Single Mode Testing Kit OR
Multi-Mode Testing Kit OR
Encircled Flux Multi-Mode Testing Kit
Single Mode Testing Kit
Multi-Mode Testing Kit
EF Multi-Mode Testing Kit
4