The One Touch Access Buttons - Viavi Certifier40G User Manual

1. The Status bar displays the current date, talk set and battery level.
2. The Configuration group provides selection on number of jumper(s) referencing is
set to, and determine single or bi-directional test is performed during an AUTOTEST.
3. The Test Settings group provides results oriented configurations necessary to
perform an AUTOTEST.
The Project Settings group provides non-results oriented configurations before
4.
performing an AUTOTEST.
The System Settings group settings provides device, time, localization and device
5.
related configurations. The Information group at the top provides hardware
information such as the device Information (Local/Remote), name, battery level, etc.

The One Touch Access Buttons

The fundamental philosophy behind the Certifier User Interface is simplicity in its ease of
use. The main functions of the One-Touch access buttons as follows:
AUTOTEST
The "AUTOTEST" button will perform an immediate certification test on the last
configured settings. If no settings were configured, default settings will be used.
Test results will be generated automatically after the test is completed.
You will receive any of the following 4 results after the "AUTOTEST":


more test parameters.
You will be given the following option after performing an AUTOTEST:

"Save" test results to device
An "AUTOTEST" will fail in the event of missing connection between the Local and Remote
units, wrong settings configured, "dirty" end connectors or broken cables.
Green "PASS" – Good test result in accordance to pre-defined settings.
Red "FAIL" – Unacceptable results with severe disturbance on one or