Viavi Certifier40G User Manual page 25

For 3 jumpers dual-ended,
1. Connect FC1 to the Local TX port and SC1 to coupler 1.
2. Connect SC5 to the Local RX port and SC6 to coupler 2.
3. Connect FC2 to the Remote TX port and SC2 to coupler 4.
4. Connect SC3 to the Remote RX port and SC4 to coupler 3.
5. Connect your jumper's SC end SC7 to coupler 1 and SC8 to coupler 3.
6. Connect your jumper's SC end SC9 to coupler 2 and SC10 to coupler 4.
Please ensure the fiber cables are cleaned using the cleaning kit provided in the kit.
FC1 SC5
TX RX
7. Press the SETUP button > Testing Settings > Reference Method and select "Three
Jumper" in the Remote Unit.
8. Press the TOOLS button > Set Reference and press the "ok" button to begin set
reference.
9. Check that the Set Reference result is ≤0.15 dB before proceeding. Clean or replace
reference cords if necessary, and set reference again if value exceeds 0.15 dB.
SC1 SC7 SC8
SC6 SC9 SC10
SC4
SC2
FC2 SC3
TX RX