MMEF Fiber AUTOTEST results
If Bi-direction is selected, swap the TX and RX connections on both ends when prompted.
SETUP
The "SETUP" button provides setting options necessary to conduct an AUTOTEST and
configure the device.
These options include –
Configuration
provides selection of the number of jumper(s) is used for setting reference on
Configuration
dual or single ended loopback, and determines if single or bi-directional test is performed
during an AUTOTEST.
Detailed results for 850nm
Swapping of TX and RX for
Single-ended loopback
testing.
Detailed results for 1300nm
Swapping of TX and RX for
Dual-ended testing.