User Function: Enable/Disable Receiver - S-COM 7K Manual

User Function: Enable/Disable Receiver

Enables or disables the receiver on the currently active remote
base radio.
• The receiver can be enabled or disabled.
Command Form:
Command
Enable/Disable Receiver
Macro: Select Enable/Disable Receiver
(Stored until (RBPW) 39 sent.)
Acknowledgment: Sends OK
Errors:
Error
OFF
? err 1
? err 2
Default Condition: The receiver is enabled when a VFO frequency or memory
channel is selected.
Example:
To enable the receiver, enter the following:
(RBPW) 44 1 *
To disable the receiver, enter the following:
(RBPW) 44 0 *
Remote Base Interface
Form
(RBPW) 44 x *
0 = OFF (disable)
1 = ON (enable)
(RBPW) 24 x *
Meaning
remote base is disabled
wrong number of digits entered
illegal digit entered
21-21