Table of Contents
Advertisement
Changes the name of an existing macro.
• The digits (contents) stored under the macro's name are not affected.
• The macro names (old and new) must be entered using 4 digits.
• If either (or both) is shorter than 4 digits, enter leading zeroes.
Command Form:
Command
Rename Macro
Acknowledgment: Sends OK
Errors:
Error
? err 1
? not found
? name used
Default: None
Examples:
Assume that a macro exists under the name 6A, and that we wish to change its
name to 1000. Enter the following command:
(PW) 27 006A 1000 *
Note: A macro name of 1000 would cause a conflict if the autopatch password
were left at its default value of 10. Be sure to select your macro names and
passwords carefully.
Rename Macro
Form
(PW) 27 (old name, new name) *
Meaning
wrong number of digits entered
old name does not exist in the directory
new name already exists in the directory
Macros
6-13
Advertisement
Table of Contents
