Table of Contents
Advertisement
Acknowledgment for Abbreviated Responses:
• When the VFO of the remote base radio is selected, an abbreviated version
of the actual frequency is spoken. For example, "545" is spoken for
"145.450" or "445.450".
• When a memory channel of the remote base radio is selected, the memory
channel number is spoken.
• If the transmitter is enabled, the controller speaks the currently selected
offset: "Minus" or "Plus" or nothing for simplex.
• If no CTCSS tone is selected for encode or decode, there is no response.
• If a tone is selected for either encode or decode, the controllers says just
the CTCSS frequency. For example, for a CTCSS frequency of 123.0 Hz,
"one two three zero" is spoken.
Errors:
Error
OFF
? err 1
? err 2
Default Condition: None.
Examples:
To have the controller speak just the frequency and transmitter status of the
remote base radio currently selected, enter the following:
(RBPW) 19 *
or:
(RBPW) 19 0 *
To verify the current CTCSS frequency and whether the radio is configured for
encode or decode, enter:
(RBPW) 19 1 *
The hear the complete status of the radio, enter:
(RBPW) 19 2 *
The hear an abbreviated status of the radio, enter:
(RBPW) 19 5 *
Remote Base Interface
Meaning
remote base is disabled
wrong number of digits entered
illegal digit entered
21-15
Advertisement
Table of Contents
