Command: Select Repeater Access Mode (Path 1) - S-COM 7K Manual

7K • Chapter 18
Select Repeater Access Mode (Path 1)
Selects one of seven possible Access Modes for Path 1.
• Enter one digit from the Repeater Access Mode Table below.
Command Form:
Command
Select Repeater Access Mode (Path 1)
Mode
0
1
2
3
4
5
6
Acknowledgment: Sends OK
Errors:
Error
? err 1
? err 2
Default Condition: Access Mode for Path 1 is Mode 1 (Carrier Access)
Note: Repeater access mode may be made different from DTMF decoder
access mode, if desired. (See page 11-5.)
18-2
Repeater Access
No Access
Carrier Access
PL Access
And-PL Access
Or-PL Access
Anti-PL Access
Always Access
Form
(PW) 57 00 x *
Explanation
Activity on the COR and PL inputs is ignored.
Activity on the COR input will key the
transmitter; activity on the PL input is ignored.
Activity on the PL input will key the transmitter;
activity on the COR input is ignored.
Activity on both the COR and PL inputs
simultaneously will key the transmitter.
Activity on either the COR or PL inputs will key
the transmitter.
Activity on the COR input simultaneously with
no activity on the PL input will key the
transmitter.
Activity on the COR and PL inputs is ignored.
The path is always enabled.
Meaning
wrong number of digits entered
illegal digit entered
Data Digit (Mode)
Repeater Access
Mode Table (below)