Receiver-Specific Autopatch Access; Preventing Multiple Accesses - S-COM 7K Manual

7K • Chapter 7
To route receiver #1 command responses to transmitter #1 and receiver #2
command responses to transmitter #2, enter the following commands:
(PW) 91 00 1 * ; Rx1 AP Resp Msgs to Tx1
(PW) 91 01 2 * ; Rx2 AP Resp Msgs to Tx2

Receiver-Specific Autopatch Access

In order to be able to set up the audio routing properly, receiver-specific
access-triggered macros have been defined (see page 7-69). These macros
are executed when the autopatch is accessed from a specific receiver. If a
receiver-specific access-triggered macro is not defined, the original access-
triggered macro, now the default, is executed (see page 7-16).
When the Rx1/Tx1 and Rx2/Tx2 ports are linked together and you don't intend
to have the users be able to link and delink the ports, you can just configure
the paths as defined in the section above.
When the ports are not linked, you need to define separate macros for
receiver #1 and receiver #2. These macros will configure the audio routing for
autopatch access from each port. To setup the routing for receiver #1, enter
the following commands:
(PW) 20 9000 (PW) 63 87 1 *
(PW) 29 9000 (PW) 63 90 1 *
(PW) 29 9000 (PW) 63 88 0 *
(PW) 29 9000 (PW) 63 91 0 *
(PW) 26 75 9000 *
To setup the routing for receiver #2, enter the following commands:
(PW) 20 9001 (PW) 63 88 1 *
(PW) 29 9001 (PW) 63 91 1 *
(PW) 29 9001 (PW) 63 87 0 *
(PW) 29 9001 (PW) 63 90 0 *
(PW) 26 76 9001 *

Preventing Multiple Accesses

When Rx1/Tx1 and Rx2/Tx2 are not linked, it is important to prevent an
autopatch in progress on one port from being interrupted by an access on the
other port. The Require Dump Before Next Call command configures this
option (see page 7-21). To prevent this access, enter the following command:
(PW) 63 10 1 * ;Require Dump Before Next Call
7-66
; Rx1 to AP Enabled
; AP to Tx1 Enabled
; Rx2 to AP Disabled
; AP to Tx2 Disabled
; Assign Rx1 Macro
; Rx2 to AP Enabled
; AP to Tx2 Enabled
; Rx1 to AP Disabled
; AP to Tx1 Disabled
; Assign Rx2 Macro