Table of Contents
Advertisement
7K • Chapter 7
Select Autopatch Command Response Message
Allows programmer to specify where to route autopatch command
response messages by receiver.
• Each receiver can be assigned its command response message routing
when accessing the autopatch.
• This command affects the Dialing, Dump, Off, Busy, Reject, Error, and
No-Redial-Number messages. (See pages 7-6, 7-51, and 7-52.)
• Enter the password, the 4-digit root number, and 1 or 2 digits representing
the transmitters to play command responses messages, and the (*).
Command Form:
Command
Select Rx1 Autopatch Command Response
Message Routing
Select Rx2 Autopatch Command Response
Message Routing
Select Rx3 Autopatch Command Response
Message Routing
Acknowledgment: Sends OK
Errors:
Error
? err 1
? err 2
Default Condition: No macros assigned.
7-68
Routing
Form
(PW) 91 00 x x *
(PW) 91 01 x x *
(PW) 91 02 x x *
Meaning
wrong number of digits entered
illegal digit entered
Data Digit
1 = Tx1
2 = Tx2
1 = Tx1
2 = Tx2
1 = Tx1
2 = Tx2
Advertisement
Table of Contents
