Table of Contents
Advertisement
7K • Chapter 4
Beep Messages
Control Character
The control character 9910 must be entered before the actual beep characters
when building a beep message.
Note: Any message that does not have a control character will be interpreted
as a CW message.
Format
The format for beep messages is as follows:
• Enter the control character 9910.
• Then enter the various beep character codes described in the Beep
Character Set Tables beginning on page A-5 to create the desired
message.
• You may end the beep message with the (*) character, or enter another
control character (99xx) and continue with another message type.
Beep Parameters (General)
The following table shows the general parameters related to beep messages.
These parameters will be discussed in more detail in the sections which follow:
Parameter
custom beep
custom beep delay
1 second pre-message delay
automatic beep gap OFF
automatic beep gap ON
Pre-Message Delay Character
A special pre-message delay character, 54, can be programmed—after the
control character 9910 but before the beep characters. The delay character
(54) causes the message handler to pause for 1 second before sending the
beep message. Any additional 54s found after the first one will be ignored. If
the beep message was preceded by any other message, the 54 will be ignored.
4-16
Beep Parameters (General)
Control Character 9910
Code
57xxxxyy
58xx
54
55
56
Advertisement
Table of Contents
