Table of Contents
Advertisement
Select Frequency of Owner-Fixed Frequency Beeps
Changes the frequency (pitch) of the CW.
• Enter the password, followed by the 4-digit root number shown, followed by
the 4-digit tone code for your desired frequency.
• The tone code is taken from the Tone Code Table on page A-20. Do not
omit leading zeroes. Tone codes may also be calculated, if desired.
• The frequency range is 100Hz to 5KHz, although most radio systems have
an audio response of 300Hz to 3KHz.
• To select frequencies for CW and CTCSS, see the appropriate commands
on pages 4-11 and 10-3 respectively.
Command Form:
Command
Select Frequency of Beep 48
Select Frequency of Beep 49
Select Frequency of Beep 50
Select Frequency of Beep 51
Select Frequency of Beep 52
Select Frequency of Beep 53
Acknowledgment: Sends OK
Errors:
Error
? err 1
? err 2
Default Condition:
Command
Select Frequency of Beep 48
Select Frequency of Beep 49
Select Frequency of Beep 50
Select Frequency of Beep 51
Select Frequency of Beep 52
Select Frequency of Beep 53
Form
(PW) 06 01 xxxx *
(PW) 06 02 xxxx *
(PW) 06 03 xxxx *
(PW) 06 04 xxxx *
(PW) 06 05 xxxx *
(PW) 06 06 xxxx *
Meaning
wrong number of digits entered
illegal code entered
Default Condition
500Hz
750Hz
1000Hz
1250Hz
1500Hz
1750Hz
Messages
Data Digits
Tone Code Table
Tone Code Table
Tone Code Table
Tone Code Table
Tone Code Table
Tone Code Table
Tone Code
2000
1333
1000
0800
0667
0571
4-19
Advertisement
Table of Contents
