Table of Contents
Advertisement
Causes the controller to stop the execution of the commands that
follow for the programmed amount of time.
• This results in a delay occurring between commands.
• Enter 3 digits corresponding to the number of seconds of pause desired.
Command Form:
Command
Pause
Acknowledgment: None
Errors:
Error
? err 1
? err 2
Default Condition: No Pause
Examples:
To delay command execution 2 seconds, enter:
(PW) 98 2 *
To delay command execution 10 seconds, enter:
(PW) 98 10 *
Note: Very long delays are not recommended, as the controller will not store
commands which are input via DTMF during this time. However , macro
execution will not be affected, and Pause commands may be stored as desired
in strings of macros.
Pause
Form
(PW) 98 xxx *
Meaning
wrong number of digits entered
illegal digit entered
Macros
Data Digit
(001–255)
= (1–255) seconds
6-15
Advertisement
Table of Contents
