Table of Contents
Advertisement
7K • Chapter 12
Select ID Pending Interval For Tx1 and Tx2
Programs the amount of time the controller "looks ahead" to send a
polite ID.
• The Pending ID Interval is the amount of time before the end of the ID
Message Interval (see page 12-5) that the controller looks for the repeater's
carrier to drop to insert a polite ID.
• A longer interval allows more time for a polite ID to occur, but can cause an
ID to occur more often than required.
• Enter 1, 2, 3, or 4 digits, leading zeroes are not required.
Command Form:
Command
Select ID Pending Interval for Tx1 and Tx2
Acknowledgment: Sends OK
Errors:
Error
? err 1
? err 2
Default Condition: The ID Pending Interval is 30 seconds.
Example:
To select an ID Pending Interval of 2 minutes (120.0 seconds), enter the
following:
(PW) 49 97 1200 *
12-6
Form
Data Digits
(PW) 49 97 xxxx *
(0300-1800) = 30.0-
180.0 seconds
Meaning
wrong number of digits entered
illegal digit entered
Advertisement
Table of Contents
