Table of Contents
Advertisement
7K • Chapter 7
Autopatch Timeout Timer
The Autopatch Timeout Timer controls the duration of the call. If the call
exceeds the time limit, it will be terminated by the controller.
When the time is within 30 seconds of "timing out," the autopatch timeout timer
will start sending short Autopatch Timeout Warning Messages in CW. These
messages are sent every 5 seconds, and are programmable. A user may
extend the duration of his/her call by entering the Reset Autopatch Timeout
Timer command on page 7-26.
If the repeater owner does not want to make the Reset Autopatch Timeout
Timer command available to users, he/she should simply not create a macro
containing it. The command will remain a control command, protected by its
password.
7-24
Advertisement
Table of Contents
