Command: Assign Control Operator Password - S-COM 7K Manual

7K • Chapter 5
Assign Control Operator Password
Assigns a new password for control operators.
• The new Control Operator Password may be 2, 4, or 6 digits in length.
• The new Control Operator Password may be any combination of the
numbers 0-9 and the letters A-D.
• Autopatch passwords are explained in the Autopatch section on page 7-2.
• Remote base passwords are explained in the Remote Base Interface
section on page 21-1.
Command Form:
Command
Assign Control Operator Password
Acknowledgment: Sends OK
Errors:
Error
? err 1
Default Condition: No Control Operator Password is assigned
Examples:
Assume there there is no control operator password, the default condition. To
assign it to 95, enter this:
(PW) 92 95 *
"(PW)" must be the master password, since no control operator password
exists.
If the master password is 2A3B4C, enter this:
2A3B4C 92 95 *
5-2
Form
(PW) 92 (new control operator password) *
Meaning
wrong number of digits entered