Standard Bin 1 Full - Lexmark W850n Service Manual

Standard bin 1 full

Step
1 Check the actuator for movement.
Does the standard bin 1 full actuator move up and down
normally?
2 Check the sensor (standard bin full exit 1) for operation.
1. Enter Diagnostics mode.
2. Select BASE SENSOR TESTS.
3. Select Exit level.
4. Select Standard bin full exit1.
Does the display on the operator panel change every time
the sensing area is blocked?
3 Check the sensor (standard bin full 1) connection.
Is the sensor (standard bin full 1) properly connected?
4 Check the exit interface card assembly connection P432,
P433, and P434.
Is the exit interface card assembly properly connected
P432, P433, and P434?
5 Perform a print test.
Does the error continue?
Check Yes
Go to step 2. Reinstall the
standard bin 1 full
actuator.
Go to step 5. Go to step 3.
Replace the Replace the
sensor (standard connection.
bin full exit 1).
Go to step 4.
Go to "Sensor
(exit 1 bin full)
removal" on
page 4-109.
Replace the exit Replace the
interface card connection.
assembly.
Go to "Exit
interface card
assembly
removal" on
page 4-117.
Replace the Problem solved.
printer engine card
assembly.
Go to "Printer
engine card
assembly
removal" on
page 4-119.
Diagnostic information
4024-110
Previous
No
Next
Go Back
2-73