Lexmark W850n Service Manual page 40

4024-110
Error code or
message
981.00
Service
finisher error
981.01
Service
finisher error
981.02
Service
finisher error
982.00
Service
finisher error
982.01
Service
finisher error
983.00
Service
finisher error
983.01
Service
finisher error
984.00
Service
finisher error
984.01
Service
finisher error
985.00
Service
finisher error
2-18
Printer Service Manual
Error contents
Stacker bin failure
Stacker bin upper limit failure
Stacker bin lower limit failure
Sensor (front tamper HP) on
failure
Sensor (front tamper HP) off
failure
Sensor (rear tamper HP) on
failure
Sensor (compiler rear tamper
HP) off failure
Sensor (punch unit HP) on
failure
Sensor (punch unit HP) off
failure
Sensor (punch carriage shift
HP) on failure
Description/Action
The sensor (stacker bin level) is not turned on within
the specified period after the stacker bin starts
rising.
Refer to Finisher Service Manual.
The stacker bin abnormally rises beyond the
specified upper limit position (stacker bin level).
Refer to Finisher Service Manual.
The stacker bin abnormally lowers beyond the
specified lower limit position (full stack).
Refer to Finisher Service Manual.
The sensor (front tamper HP) is not turned on after
the front tamper starts moving to the front tamper
home position.
Refer to Finisher Service Manual.
The sensor (front tamper HP) is not turned off within
the specified time after the front tamper starts
leaving from the front tamper home position.
Or the sensor (front tamper HP) is turned on again
after the sensor (compiler front tamper HP) is turned
off, and the front tamper stopped its moving.
Refer to Finisher Service Manual.
The sensor (rear tamper HP) is not turned on after
the rear tamper starts moving to the rear tamper
home position.
Refer to Finisher Service Manual.
The sensor (compiler rear tamper HP) is not turned
off within the specified time after the rear tamper
starts leaving from the rear tamper home position.
Or the sensor (compiler rear tamper HP) is turned
on again after the sensor (compiler rear tamper HP)
is turned off, and the rear tamper stopped its
moving.
Refer to Finisher Service Manual.
The sensor (punch unit HP) is not turned on even
when the specified time passed after the punch unit
motor is turned on.
Refer to Finisher Service Manual.
The sensor (punch unit HP) is not turned off even
when the specified time passed after the punch unit
motor is turned on.
Refer to Finisher Service Manual.
The sensor (punch carriage shift HP) is not turned
on even when the specified time passed after the
punch carriage shift motor assembly is turned on.
Or the sensor (punch carriage shift HP) is turned off
again after the sensor (punch carriage shift HP) is
turned on and the punch carriage shift motor
assembly stopped its rotation.
Refer to Finisher Service Manual.
Previous
Next
Go Back