Finisher Tests - Lexmark W850n Service Manual

4.
Each of the tests categories includes the individual sensors that can be manually actuated, and the display
shows Open or Closed.
•
Standard Bin
Std bin full exit1
Std bin full exit2
•
Output Bin 1
Fin upper bin full
•
Output Bin 2
Stacker bin level1
Stacker bin level2
Manually actuate the selected sensor, and Open or Closed displays.
5.
Press Back ( ) or Stop (

FINISHER TESTS

Staple Test
This test verifies the staple mechanism by sending eight sheets of media from the printer's default paper source
and stapling the sheets.
To run the Staple Test:
1.
Select FINISHER TESTS from DIAGNOSTICS.
2.
Select Staple Test from FINISHER TESTS.
3.
Select the output bin, and press
While the test runs the power indicator blinks and the message Staple Test Running... displays. Select
Stop ( ) to exit the test before it completes.
Hole Punch Test
This test is used to verify whether or not media can be fed to a finisher output bin and punched. Eight sheets of
blank paper are fed from the default paper source and fed to the finisher output bins. Letter size paper is used
for the 3 hole test, and A4 media is used for the 4 hole test. Media is selected from the default tray.
To run the Feed Test:
1.
Select FINISHER TESTS from DIAGNOSTICS.
2.
Select Feed Tests from FINISHER TESTS.
While the feed test runs, the power indicator blinks, and the message Feed Test Running... displays.
During the test, no buttons are active, and the test cannot be stopped until the test is completed.
Feed Tests
This test is used to verify whether or not media can be fed to a finisher output bin. Eight sheets of blank paper
are fed from the default paper source and fed to the finisher output bins.
Note: This test can be run using any of the paper sizes supported by the printer.
To run the Feed Test:
1.
Select FINISHER TESTS from DIAGNOSTICS.
2.
Select Feed Tests from FINISHER TESTS.
While the feed test runs the power indicator blinks and the message Feed Test Running... displays.
During the test, no buttons are active and the test cannot be stopped until the test is completed.
) to exit the test.
.
4024-110
Previous
Go Back
3-11
Diagnostic aids
Next