Printer Setup - Lexmark W850n Service Manual

Flash Test
This test verifies the functioning of the flash device by writing and reading data on the flash to test the flash.
Warning: This test destroys all data on the flash, because the flash is unformatted at the end of the test. To
reformat the flash, the servicer or the user must use FORMAT FLASH from the UTILITIES MENU.
To run the Flash Test:
1.
Select DEVICE TESTS from DIAGNOSTICS.
2.
Select Flash Test from DEVICE TESTS.
The message Files will be lost/Go or Stop? displays to warn the user that all contents on the flash
device will be lost.
3.
To exit the test immediately and return to the Device Tests menu, press Back (
continue with the test, press
The power indicator blinks while the test is running, and the message Flash Test Testing... displays.
Once the test is complete, the power indicator turns on solid, and either the message Flash Test Test
Passed or Flash Test Test Failed displays.
Press Back ( ) or Stop (

PRINTER SETUP

Defaults
US/Non-US defaults changes whether the printer uses the US factory defaults or the non-US factory defaults.
The settings affected include paper size, envelope size, PCL symbol set, code pages, and units of measure.
Warning: Changing this setting resets the printer to factory defaults, and data may be lost. It cannot be undone.
Page Count
The page count can only be viewed and cannot be changed.
To view the page count:
1.
Select PRINTER SETUP from DIAGNOSTICS.
2.
Select Page Count from PRINTER SETUP.
3.
Press Back (
Perm Page Count (permanent page count)
The permanent page count can only be viewed and cannot be changed.
To view the permanent page count:
1.
Select PRINTER SETUP from DIAGNOSTICS.
2.
Select Perm Page Count from PRINTER SETUP.
3.
Press Back (
.
) to return to DEVICE TESTS.
) to return to PRINTER SETUP.
) to return to PRINTER SETUP.
4024-110
Previous
Go Back
) or Stop ( ). To
3-15
Diagnostic aids
Next