Tray 2 Media Size Mismatch In Length - Lexmark W850n Service Manual

Step
13 Perform a print test
Does the error continue?

Tray 2 media size mismatch in length

Step
1 Check the media.
Pull out tray 2, and visually check it.
Is media loaded in tray 2 properly?
2 Check the media.
Pull out tray 2, and check it.
Are the front media tray guide assembly, rear media tray
guide, and media tray end guide of tray 2 set correctly?
3 Check the switch (media size) for tray 2 installation.
Is the switch (media size) for tray 2 installed correctly?
Pull out tray 2, and check it.
4 Check the switch (media size) for tray 2 connection.
Is the switch (media size) for tray 2 properly connected?
5 Check the roll for tray 2.
Pull out tray 2, and check it.
Is the feed roll, separation roll, and pick roll free of excess
wear and contamination?
6 Open the printer left door assembly, and check it.
Check the media position.
Does the media touch the sensor (registration)?
Check
Check
Yes
Replace the Problem solved.
printer engine card
assembly.
Go to "Printer
engine card
assembly
removal" on
page 4-119.
Yes
Go to step 2. Load media
properly.
Go to step 3. Set the guides
properly.
Go to step 4. Install the switch
(media size) for
tray 2 correctly.
Go to "Switch
(media size)
removal" on
page 4-17.
Replace the switch Replace the
(media size). connection.
Go to "Switch
(media size)
removal" on
page 4-17.
Go to step 6. Clean or replace
the feed roll,
separation roll,
and pick roll.
Go to "Feed roll
removal" on
page 4-42,
"Separation roll
removal" on
page 4-46, and
"Pick roll
removal" on
page 4-48.
Remove the Go to step 7.
media.
Diagnostic information
4024-110
Previous
No
Next
Go Back
No
2-81