Standard Bin Full; Stopping; Submitting Selection; Too Many Failed Panel Logins - Lexmark E460dw User Manual

Standard Bin Full

Remove the stack of paper from the standard exit bin to clear the message.

Stopping

Wait for the message to clear.

Submitting selection

Wait for the message to clear.

Too many failed panel logins

The printer is now in a lockout mode because:
•
You attempted to log in too many times with an incorrect PIN
•
You attempted to log in using an incorrect password number for access to a printer feature, setting, or menu that
you do not have access to.
Note: There is a defined limit on the number of login attempts. Once the limit is reached, this message appears and
the printer enters a lockout mode. The message remains on the printer control panel, and any further attempts to
enter menus is denied until the defined time out expires. The time out duration is set by your system support person.
Wait for the message to clear once the time out expires, and then:
•
Enter the correct PIN to access any held jobs
•
See your system support person if you need a password number to enter a specific printer feature, setting, or
menu that is blocked from your use without the number.
Tray <x> disabled
The specified tray is disabled from the Disable Hardware menu of the Config menu. To clear the message, enable the
specified tray through the same menu. Consult your system support person for help.
Tray <x> Missing
Insert the specified tray into the printer.

30.yy Invalid refill, change cartridge

An unsupported, refilled toner cartridge is installed. Remove the toner cartridge, and then install a new one.

31.yy Replace defective or missing cartridge

The toner cartridge is either missing or not functioning properly.
Try one or more of the following:
•
Remove the toner cartridge, and then reinstall it.
•
Remove the toner cartridge, and then install a new one.
Troubleshooting
141