Exit 1 Drive Belt Removal - Lexmark W850n Service Manual

Exit 1 drive belt removal

1.
Remove the rear RIP card cover. See
2.
Remove the rear motor cover. See
3.
Remove the standard exit top cover. See
4.
Release the hook on the drive belt flange (A).
5.
Remove the drive belt flange (A).
6.
Remove the exit 1 drive belt (B) from the drive pulley - 25 tooth (C).
Note: The drive pulley -25 tooth (C) may become detached.
7.
Remove the exit 1 drive belt (B) from the exit 1 media shift assembly (D).
Note: Press on the exit 1 drive belt (B) while slowly turning the motor (E) by hand.
"Rear RIP card cover removal" on page
"Rear motor cover removal" on page
"Standard exit 1 top cover removal" on page
B
D
Left side view
B
C
Hook
A
4-14.
E
Rear
4024-110
4-125.
4-112.
4-113
Repair information
Previous
Next
Go Back