Standard Exit 1 Top Cover Removal; Exit 1 Drive Belt Removal - Lexmark W840 Service Manual

4024-XXX

Standard exit 1 top cover removal

1.
Remove the standard exit 1 top cover (A) by moving it toward the rear then lifting it upward in the direction
of the arrow.

Exit 1 drive belt removal

1.
Remove the rear RIP card cover. See
2.
Remove the rear motor cover. See
3.
Remove the standard exit top cover. See
4.
Release the hook on the drive belt flange (A).
5.
Remove the drive belt flange (A).
6.
Remove the exit 1 drive belt (B) from the drive pulley - 25 tooth (C).
Note: The drive pulley -25 tooth (C) may become detached.
4-114
Printer Service Manual
"Rear RIP card cover removal" on page
"Rear motor cover removal" on page
"Standard exit 1 top cover removal" on page
A
Rear
4-127.
4-15.
4-114.