Exit Drive Belt Removal - Lexmark 5000 Service Manual

4093/4094

Exit Drive Belt Removal

1. Remove all covers, refer to
page 4-5.
2. Remove the carrier frame assembly.
3. Remove the two screws from the star roller assembly and
remove the assembly. Do not overtighten the screws, as this
may strip the plastic.
4. Remove the printhead carrier assembly.
5. Remove the maintenance station.
6. Unhook the springs from the small feed rollers.
7. Remove the small feed rollers by unlatching them from the feed
roller holder.
8. Remove the mid-frame assembly by pushing it forward from the
rear and out of the machine.
9. Remove the right large feed roller bushing.
10. Remove the large feed roller.
11. Remove the exit roller assembly.
12. Replace the exit drive belt.
Exit Roller Removal
1. Open the access door.
2. Remove the two screws from the star roller assembly and
remove the assembly. Do not overtighten the screws, as this
may strip the plastic.
3. Unlatch the right side of the exit roller and remove the exit drive
belt from the exit roller pulley.
4. Remove the exit roller.
4-8
Service Manual
"Covers (Complete) Removal," on