Panasonic KX-NS1000 Operating Manual page 316

3.2.1 User Programming
Button
Wrap-up
System Alarm
Time Service (Day/Night/
Lunch/Break)
Answer
Release
Toll Restriction/Call Barring
ISDN Service
Calling Line Identification
Restriction (CLIR)
Connected Line Identification
Restriction (COLR)
ISDN-Hold
Headset
Time Service Switching Mode
(Automatic/Manual)
Network Direct Station
Selection (NDSS)
CTI
Primary Directory Number
(PDN)
316 Operating Manual
Select Wrap-up from Type.
Select System Alarm from Type.
Select Time Service from Type.
Then in Parameter Selection, select which time modes will be
switched manually.
In Optional Parameter (Ringing Tone Type Number), select the Time
Table (tenant number) to be used for changing time modes in Automatic
Switching mode.
Select Answer from Type.
Select Release from Type.
Select TRS Level Change from Type.
Then select the Toll Restriction/Call Barring Level (1–7) from Parameter
Selection.
Select ISDN Service from Type.
Then enter the desired number in Dial (max. 32 digits consisting of 0–9,
, #, T [Transfer], [ ] [Secret], P [Pause], and F [Flash]).
Note
Availability of this button depends on the ISDN service of your
telephone company.
Refer to "1.2.5 Accessing the ISDN Service (ISDN Service
Access)".
Select CLIR from Type.
Select COLR from Type.
Select ISDN Hold from Type.
Select Headset from Type.
Select Time Service - Automatic/Manual from Type.
Then in Parameter Selection, select the Time Table (tenant number) to
be used when Time Service Switching Mode is set to Automatic.
Select NDSS from Type.
Then enter the another PBX extension number in Dial (max. 16 digits
consisting of 0–9).
Note
The button may not be available depending on the networking
method in use or the settings of the PBX.
Select CTI from Type.
Select PDN from Type.
Steps