Panasonic KX-NS1000 Operating Manual page 314

3.2.1 User Programming
Button
Loop-CO (L-CO)
Group-CO (G-CO)
Single-CO (S-CO)
Direct Station Selection (DSS)
One-touch Dialling
Incoming Call Distribution
Group (ICD Group)
Message
314 Operating Manual
2. To set the flexible buttons, specify each button on the
Flexible Button screen.
Follow the table below to set each parameter. When
you finish, click OK.
Select Loop CO from Type.
To specify the ring tone, select the ring tone type from Optional
Parameter (Ringing Tone Type Number).
Select Group CO from Type.
Then specify the outside line group number in Parameter Selection.
To specify the ring tone, select the ring tone type from Optional
Parameter (Ringing Tone Type Number).
Select Single CO from Type.
Then specify the outside line number in Parameter Selection.
To specify the ring tone, select the ring tone type from Optional
Parameter (Ringing Tone Type Number).
Select DSS from Type.
Then enter the extension number in Extension Number.
Select One-touch from Type.
Then enter the desired number in Dial (max. 32 digits consisting of 0–9,
, #, T [Transfer], [ ] [Secret], P [Pause], and F [Flash]).
Note
•
If you store an outside party's number, you should first store a
line access number.
If you need to enter an account code, you can enter the specified
account code before the line access number.
<Example>
49 1234
Account code Account
feature no. code
•
For KX-UT series SIP phones and S-PS users:
Use only 0–9,
characters other than these are stored, they will be considered
invalid. Only the digits up to an invalid character will be sent
when using that One-touch Dialling button.
Select ICD Group from Type.
Then enter the incoming call distribution group extension number in
Extension Number.
To specify the ring tone, select the ring tone type from Optional
Parameter (Ringing Tone Type Number).
Select Message Waiting from Type.
Steps
#
Account code Automatic line
delimiter access number
, and # for One-touch Dialling buttons. If
SECRET
0/9 [ 123 4567 ]
Phone number