Panasonic KX-NS1000 Operating Manual page 303

Item
Telephone Device—Device
Notification Timer—Device
Start Delay Time (0-120 min)
Dial Number [0-9 * # T X , ;]
Assigns a telephone number to Device 1, 2, or 3. You can also specify
the number to be dialled by entering it from your telephone, allowing
you to set this feature on a case by case basis.
Enter a maximum of 32 digits consisting of 0–9,
•
,: Dial Pause (default 1 s)
•
;: Dial Pause (default 3 s)
•
T: Dial Tone Detection
•
X: Callback Number Entry Code
•
0–9, , #: Dial Code
Note
If you are using a PRI line, you may need to enter # at the end of
outside telephone numbers.
No. of Retries
Specifies the number of times the Unified Messaging system will try to
send notification if the device is busy or if there is no answer.
Busy Delay Time (min)
Specifies the time (in minutes) the Unified Messaging system waits
before retrying message notification when the called device is busy.
No Answer Delay Time (min)
Specifies the time (in minutes) the Unified Messaging system waits
before retrying message notification when the called device does not
answer.
Use Mode
Specifies if and how each device is used for message notification. You
can also specify the use mode from your telephone:
•
Not use: The selected device is not used for message notification.
•
Continuously: The device is called whenever a message is recorded
in the mailbox. If Only Urgent Messages is set to "Yes", the device
is called whenever an urgent message is recorded in the mailbox.
•
Scheduled: The selected device is called only during the selected
times.
Time Frame: If Scheduled is selected here, follow the steps below to
specify the time frame:
1. Click a day (Sunday – Saturday) tab.
2. Click Enable Time Frame No. 1 or 2.
3. Enter the start and end times in the "Start At (HH:MM)" and "End At
(HH:MM)" fields.
4. Repeat steps 1 to 3 for each day to be programmed, and then Click
OK.
Specifies the length of time the system waits after a new message is
received before sending message waiting notification.
3.2.1 User Programming
Description
, # and special codes:
Operating Manual 303